In this design by Janelle Interiors, a closet is transformed into a sleek and modern workspace, with a built-in desk and shelving, as well as a bold geometric https://remotemode.net/ wallpaper accent wall. This home office utilizes the former closet depth to add built-in cabinetry inside. A small desk can still have a ton of personality.

convert closet to desk

I used a water-based polyurethane finish for my desktop and shelves, and I coated the shelf cleats with latex enamel paint. In case I ever need to remove the desk, I skipped the glue here. A few small holes are easier to repair than long swaths of paint and drywall. Then I used the torpedo level to install the side wall cleats. If you don’t find studs to which you can fasten the side cleats, use hollow-wall anchors. Plants (artificial or real) can brighten up any closet-turned-home office, while trinkets and tabletop décor can add a custom feel to your desk or bookshelves.

Violet Closet-to-Desk Conversion

Get as close as you can with the knife without cutting into the plywood itself. With the shelf edges installed, test-fit them again just to be sure. From this cut-out I was able to cut two of the four shelves. We can help you make and turn a closet into the office of your dreams a reality. Contact us today and we can get you started creating a more efficient workflow and better use of your home’s space.

convert closet to desk

Cut the piano hinge to length and attach one of its leaves to the desktop. Using a combination square, mark the placement for the folding https://remotemode.net/blog/tips-for-converting-your-closet-to-a-cozy-office/ leg brackets on the back of the leg and underside of the folding desk. Predrill holes and install the brackets with the supplied screws.

Did you make this project?

This is lovely, with so much storage above and below the desk. This design really uses every bit of space without looking cluttered. A simple painted board forms the desk, but you’d never know that from looking at it. For the U-shaped shelf, I used a mitre saw to mitre the edge pieces where they met under the shelf. For all the shelf supports I tried to hit as many studs as possible, because they are stronger. But in some places I had to use a drywall anchor instead because things just didn’t line up.

Leave a Reply

Votre adresse e-mail ne sera pas publiée. Les champs obligatoires sont indiqués avec *